CTEK 40-256 20A Off Grid Bundle-D250SA and Battery Monitor, 2 Pack

#ad
CTEK 40-256 #ad - This charging system charges your battery bank from several sources, prioritizes connections, and looks after the battery so it will not become completely flat Optimizes charging while driving to give you more time off-grid. 1 - part# 40-186 - d250sa  dual - dc/DC on-board charger. 1 - ctek  battery system monitor not Available separately.

More information about CTEK 40-256 #ad

12 Circuits with Negative Bus & Cover - Blue Sea Systems ST Blade Fuse Block

#ad
Blue Seas 5026 #ad - Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses. Can be used for 24-hour circuits. Positive distribution bus with #10-32 stud. Fuses sold separately. St blade fuse block - 12 circuits with negative bus and cover.

Fuse block, mfg# 5026, atc/ato, w/negative bus and cover, 12 circuit, 32VDC max W/30Amp max per circuit & 100Amp per block. Accepts ato and ATC fast acting blade fuses. 3. 32"w x 6. 5"h x 1. 52"d.

More information about Blue Seas 5026 #ad


Similar products



CTEK 40-185 SmartPass 120 A Energy Management Unit

#ad
CTEK 40-185 #ad - Accepts ato and ATC fast acting blade fuses. The ctek smartpass 120 converts a 110/230V charger with one output into a unit that serves both the service and starter battery. The smartpass has a 5 year Limited warranty. Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses.

Designed to properly manage and distribute power, this ensures that service batteries are protected from being deeply discharged, directing energy to where it is needed most, providing batteries with an optimal service life and reducing the frequency and need for regular traditional charging. Converts a 110/230v charger with one output into a Unit that serves both the service and starter battery, eliminating the need for units with multiple outputs.

CTEK 40-185 SmartPass 120 A Energy Management Unit #ad - St blade fuse block - 12 circuits with negative bus and cover. Combining the use of the D250SA Dual ensures optimal battery charging by managing energy transfer. It features an integrated 'battery guard' which protects deep cycle batteries from harmful total discharge and ensures that critical equipment such as radio, emergency lights and navigation systems always function.

This charger is a fully automatic energy management system which can handle up to 80A for batteries of between 28-800Ah. The smartpass 120 is an energy management unit which controls and optimizes energy produced by alternators, bow thruster batteries, such as the deep cycle bank, wind power or conventional AC/DC chargers, consumers, and distributes it to the battery banks or consumers which require energy, solar cells, etc.

The simplified installation eliminates the need for units with multiple outputs.

More information about CTEK 40-185 #ad


Similar products



Blue Sea Systems MaxiBus 250A BusBar with Four 5/16

#ad
Blue Sea Systems 2127-BSS #ad - Can be used for 24-hour circuits. Continuous rating: 250A AC/DC. Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses. Combining the use of the D250SA Dual ensures optimal battery charging by managing energy transfer.

Positive distribution bus with #10-32 stud. Built-in battery watch technology to make full use of the majority of energy produced. Bus material - tin platted copper cda 110/uns c1100 insert molded stainless steel studs eliminate need for securing nut and allow high torqueing for excellent electrical contact Raised bus provides easy access to multiple wires on a single stud.

Blue Sea Systems MaxiBus 250A BusBar with Four 5/16 #ad - . 2 mounting holes accept #10 M5 screws. Splash and dust proof makes it ideal for all environments. Ul 94-v0 rated base material resists high heat, tin plated pure electrical copper for maximum conductivity. 250a maxibus busBar with 4 studs. Has a sensor which senses the battery temperature and reduces charge current at high battery temperatures.

Accepts ato and ATC fast acting blade fuses. St blade fuse block - 12 circuits with negative bus and cover. Max voltage: 300v aC/ 48V DC.

More information about Blue Sea Systems 2127-BSS #ad


Similar products



Renogy MC4 Tool Assembly and Disassembly Tool Solar Panel Cable Crimping Tool for Male/Female MC4 Connectors

#ad
TOOL-MC4 TOOL-MC4 #ad - Combining the use of the D250SA Dual ensures optimal battery charging by managing energy transfer. Converts a 110/230v charger with one output into a Unit that serves both the service and starter battery, eliminating the need for units with multiple outputs. Accepts ato and ATC fast acting blade fuses. Hard plastic.

Continuous rating: 250A AC/DC. 2 mounting holes accept #10 M5 screws. Splash and dust proof makes it ideal for all environments. For breaking connections after they have already been locked together. Ul 94-v0 rated base material resists high heat, tin plated pure electrical copper for maximum conductivity. Very handy for the assembly of custom Mc4 wires.

Renogy MC4 Tool Assembly and Disassembly Tool Solar Panel Cable Crimping Tool for Male/Female MC4 Connectors #ad - 250a maxibus busBar with 4 studs. Max voltage: 300v aC/ 48V DC. 100% compatible with Renogy MC4 connectors. Has a sensor which senses the battery temperature and reduces charge current at high battery temperatures. Positive distribution bus with #10-32 stud. St blade fuse block - 12 circuits with negative bus and cover.

Built-in battery watch technology to make full use of the majority of energy produced.

More information about TOOL-MC4 TOOL-MC4 #ad


Similar products



Ancor 106802 Marine Grade Electrical Primary Tinned Copper Boat Wiring 12-Gauge, Red, 25-Feet

#ad
Ancor Marine Grade Products 106802 #ad - Highest quality ultra flexible Type 3 tinned copper stranding provides maximum protection against corrosion and electrolysis while resisting fatigue due to vibration and flexing. Wire gauge: 12 awg st blade fuse block - 12 circuits with negative bus and cover. Exceeds all ul 1426, us coast guard Charter boat CFR title 46 and ABYC standards.

Hard plastic. Continuous rating: 250A AC/DC. They are constructed with premium vinyl insulation that is rated at 600V, heat, stays flexible even in extreme cold -40F/C and resists salt water, gasoline, 105C dry and 75C wet, battery acid, oil, abrasion and ultra-violet radiation. They are constructed with premium vinyl insulation that is rated at 600 volts, heat, battery acid, stays flexible even in extreme cold -40 deg F/C and resists salt water, 105 deg C dry and 75 deg C wet, oil, gasoline, abrasion and ultra-violet radiation.

Ancor 106802 Marine Grade Electrical Primary Tinned Copper Boat Wiring 12-Gauge, Red, 25-Feet #ad - Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses. Manufactured from individual copper strands and tinned to perform in the harshest marine environments. 100% compatible with Renogy MC4 connectors.

2 mounting holes accept #10 M5 screws. Ul 94-v0 rated base material resists high heat, tin plated pure electrical copper for maximum conductivity.

More information about Ancor Marine Grade Products 106802 #ad


Similar products



HYCLAT Red 6-10 Gauge Battery Quick Connect/Disconnect Wire Harness Plug Connector Recovery Winch Trailer | 12-36V DC, 50A

#ad
HYCLAT Battery Connect #ad - Very easy to install:. 3. 2 mounting holes accept #10 M5 screws. Has a sensor which senses the battery temperature and reduces charge current at high battery temperatures. Ultra-flexible type 3 stranding resists fatigue from vibration and provides added corrosion protection. In the kit, a couple of boot caps are included to protect this quick connect and disconnect kist from the dust.

2. The mark of positive and negative are printed in the connector to avoid the misplug. Connector ends are identical, so either end is suitable for connection to the power or load side. 100% money back. Continuous rating: 250A AC/DC. 1. Exceeds all ul 1426, us coast guard Charter boat CFR title 46 and ABYC standards.

HYCLAT Red 6-10 Gauge Battery Quick Connect/Disconnect Wire Harness Plug Connector Recovery Winch Trailer | 12-36V DC, 50A #ad - Crimp the terminal pins. Insert the wires into the terminal pins, then solder or crimp them. 4. 250a maxibus busBar with 4 studs. Built-in battery watch technology to make full use of the majority of energy produced. This kits always are equipped in Electra, golf car, electric folk truck, forklift, tour bus and many other power-driven tools to solve the power-out problem.

More information about HYCLAT Battery Connect #ad


Similar products



SELTERM 10 Pack 6 Gauge 6 AWG 1/4" Stud UL Marine Grade Ring Terminal Lugs Battery Cable Tinned Copper Eyelets

#ad
SELTERM #ad - Insert the wires into the terminal pins, then solder or crimp them. Converts a 110/230v charger with one output into a Unit that serves both the service and starter battery, eliminating the need for units with multiple outputs. For breaking connections after they have already been locked together. Close end pad seals Out Moisture Keeping Cables Dry.

Selterm marine grade copper Lugs are manufactured using industry leading processes to guarantee a high-quality product. Very handy for the assembly of custom Mc4 wires. Can be Crimped or Soldered. Ul 94-v0 rated base material resists high heat, tin plated pure electrical copper for maximum conductivity. Diameter of the terminal pins: 1/5" Connector: 1-7/8" x 1-3/8" x 1/2".

SELTERM 10 Pack 6 Gauge 6 AWG 1/4" Stud UL Marine Grade Ring Terminal Lugs Battery Cable Tinned Copper Eyelets #ad - Has a sensor which senses the battery temperature and reduces charge current at high battery temperatures. Hard plastic. Exceeds all ul 1426, us coast guard Charter boat CFR title 46 and ABYC standards. Can be used for 24-hour circuits. Continuous rating: 250A AC/DC. St blade fuse block - 12 circuits with negative bus and cover.

Manufactured from individual copper strands and tinned to perform in the harshest marine environments.

More information about SELTERM #ad


Similar products



CTEK 56-674 Multi US 25000 8-step, Fully Automatic 12 Volt 25 Amp Battery Charger

#ad
CTEK CTK 56-674 #ad - The supply mode serves as a power supply unit which can run 12V equipment up to 25A, when changing battery important settings will therefore not be lost. If there is any question, please feel free to contact with us. Made from 100% annealed Tinned Copper for Max Current Flow. Accepts ato and ATC fast acting blade fuses.

Positive distribution bus with #10-32 stud. Easy to install. Very handy for the assembly of custom Mc4 wires. Exceeds all ul 1426, us coast guard Charter boat CFR title 46 and ABYC standards. Package include: 2x polycarbonate cover 2x hard rubber boot caps 4x terminal pins. Insert the wires into the terminal pins, then solder or crimp them.

CTEK 56-674 Multi US 25000 8-step, Fully Automatic 12 Volt 25 Amp Battery Charger #ad - Unlike less-sophisticated chargers, there is no need to disconnect the battery as this charger is specially designed not damage the electronic systems. Hard plastic. Max voltage: 300v aC/ 48V DC. Spark free and reverse polarity protected, making connecting to the battery safe and easy. It is a powerful charger for 12v batteries that require rapid charging such as in professional shops, RV’s, boats and of course cars.

Splash and dust proof makes it ideal for all environments.

More information about CTEK CTK 56-674 #ad


Similar products



Blue Sea Systems 12 Volt Dash Socket

#ad
Blue Sea Systems 1011-BBS #ad - Built-in battery watch technology to make full use of the majority of energy produced. Hard plastic. Continuous rating: 250A AC/DC. Corrosion resistant materials to ensure solid contact and low voltage drop Features watertight cap, easy installation and twist locks securely with plug Designed to withstand the rigors of wet environments and constant vibration.

Spark free and reverse polarity protected, making connecting to the battery safe and easy. Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses. Designed to withstand the rigors of wet environments and constant vibration.

Blue Sea Systems 12 Volt Dash Socket #ad - Ul tested & Approved. 250a maxibus busBar with 4 studs. Corrosion free Ideal for Marine Automotive or Outdoor Use. Fully automatic 8 step charger maximizes the life of the battery by reconditioning, charging and maintaining the battery. Combining the use of the D250SA Dual ensures optimal battery charging by managing energy transfer.

Ul 94-v0 rated base material resists high heat, tin plated pure electrical copper for maximum conductivity. St blade fuse block - 12 circuits with negative bus and cover. Converts a 110/230v charger with one output into a Unit that serves both the service and starter battery, eliminating the need for units with multiple outputs.

More information about Blue Sea Systems 1011-BBS #ad


Similar products



Blue Sea Systems m-Series Mini On-Off Battery Switch with Knob- Red

#ad
Acr Electronics 6006 #ad - Continuous rating: 250A AC/DC. Twist lock system-plug locks securely into socket. With removable knob. Hard plastic. 2. 83"w x 2. 83"h x 3. 1"d. Spark free and reverse polarity protected, making connecting to the battery safe and easy. Switches a single battery to a single load group. Accepts ato and ATC fast acting blade fuses.

Very handy for the assembly of custom Mc4 wires. Make before break contact design allows switching between battery banks without power interruption. Continuous rating: 300A, Maximum Voltage: 48V DC. Patented method for reconditioning sulfated batteries that have been sitting for long periods of time. For breaking connections after they have already been locked together.

Blue Sea Systems m-Series Mini On-Off Battery Switch with Knob- Red #ad - Ultra-flexible type 3 stranding resists fatigue from vibration and provides added corrosion protection. Mini battery switch, red, Mfg# 6006, 300A control.500a int. 48vdc. Ul tested & Approved. Insert the wires into the terminal pins, then solder or crimp them.

More information about Acr Electronics 6006 #ad


Similar products